Lithofin Splash Stop - 1 Litre

Lithofin SPLASH-STOP is a universally usable impregnator based on water-repelling siloxane compounds. The product contains sovents and has a low viscosity.

Properties

Lithofin SPLASH-STOP penetrates into porous surfaces and forms a thin coat inside the capillaries. This coat prevents the penetration of water and dirt, forcing it to remain on the surface. Surfaces stay clean longer and become easier to maintain. The water permeability is hardly affected. The appearance of the surface is not, or only slightly, altered. Lithofin SPLASH-STOP is UV-resistant and does not yellow.

Durability: outdoors, depending on weather conditions, approx. 3 to 5 years. Indoors, with correct maintenance, nearly unlimited.

Field of Use

For rendering facades and other surfaces made from natural stone (e.g. sand stone, granite, limestone) and quarry tiles, engineered stone and concrete water and dirt resistant. Suitable for indoor and outdoor use.

Directions for Use

The surface to be treated must be absorbent, clean and completely dry. Generously apply a consistent amount of Lithofin SPLASH-STOP with a brush or roller. In case of very absorbent materials, repeat the application after approx. 30 to 40 minutes. Avoid puddles, drips and foam. Do not allow the product to dry on the surface. Immediately distribute and remove surface residues with a cloth.

Please Note: always try the product in an inconspicuous area prior to use. Non absorbent and wet surfaces cannot be treated. Glass, plastics and other solvent sensitive surfaces must be protected against splashes. The surface temperature must be between 10°C and 25°C. Do not use in direct sunlight.

Drying Time: approx. 40 minutes (at room temperature)

Coverage: depending on the surface.

Sandstone: approx. 1 to 4m² per litre

Quarry tiles: approx. 5 to 8m² per litre

Rough granite: approx. 10 to 15m² per litre

Storage

Keep cool, closed and dry. Shelf life of up to three years. Open containers should be used quickly.